1/0 Red Battery Interconnect Cable 18" with 3/8" Lugs ASSEMBLED IN USA

Very high current flows in the cables that connect an inverter to the batteries, even in a Low-Voltage power system. Household appliances can draw over 100 amps, and motors may draw up to 500 amps. These cables allow the inverter to draw the current needed to support a large load.

Use these cables between individual battery cells or between battery banks. Use 1/0 cables for inverters that produce 12 volts and 3000 watts or smaller. Circuits with a higher load than this should use 2/0 or 4/0 cables. Cables are marked in red heat-shrink tubing for positive and white on black heat-shrink for negative.

• Plated Copper Lugs:
  These UL-listed lugs are made from tin-plated copper tubing with 3/8" holes, soldered or crimped to a stranded cable.
• Heat-Shrink Tubing:
  This tubing insulates the copper lugs and compression terminals. Tubing shrinks and glue inside melts when heated, sealing wires against corrosion and moisture.
• UL-Listed Battery Cable:
  This fine-stranded, very flexible cable is UL-listed for use as battery cable. It is rated MTW/THW/AWM, sunlight resistant, direct burial, 105 degrees C. Available in red or black.

Specifications